Question came out wrong :oops: Where do you put the piping. Where does it start because the front fender is bolted to the running board. Then when you get to the front. I have 3 hole in the fender and the chassis. Do I have to fit the front splash apron(not sure what the name is but that is what it ...

Thanks.

Do I put piping between the tub and the running boards?

How wo i differentiate between the left hand and rights hand fender stays and headlight stays. I see in the Moss parts list they have different part numbers.

Thanks again for all the help.

Good day

Q1) Do you fit piping between the running board and the tub?

Q2) Where are these wedges fitted on the TC? got them with the car and looks like it could be used to level the running boards but I only got 4 and the running boards have 3 tabs each.

Thanks, just placed an order with them for some other fastener kits.

Any light on how to fasten the panels to the inner tub?

Second question for the day. Do these rubber items go on top of the floor or under the floor? If you look closely I have a gap there the gearbox mounting bolt goes that is not covered by the rubber cover. Any help and info will be appreciated. Tunnel Rubber.jpg What type of fasteners is used, Wood s...

MG TC Inner Quarter Panel installation.jpg Good dat to all. Been a long time since I have posted anything, but I am back. Joined the local MG club so I can be inspired the whole time and get some help with my build. Unfortunately only 1 TC in the club. Question to the picture. I am now at the stage...

Thanks for this post - Just what I was looking for.

Thanks Tom for that remarkable piece of historic info. I work at a big car factory and it always amazes me how they builts cars before robots, PLCs and conveyors.

Appreciated. I take it it just get a few nails to keep it in place as every other rubber gets nailed to the car. :lol: Funny thing is I did not replace the A Post wood so think it is original and there are no recesses for the rubbers. Lots of nail marks. But there were no buffers when I got the car....

You have me now so curious I am tempted to fit the bonnet top pieces

Any pics please.

No idea about ligning up. Never paid any attention to it when the car was assembled and now it is all in pieces.

Have you got your scuttle/bonnet rubber fitted?

Found this in the book on adjustment points

Need some help here fellow TC owners. I would like to fit the Door Buffers as I am opening and closing my doors continuously because with the rear fenders now fitted, if the doors go all the way round I can damage the door on the fender. Question is simple, How are the Door Buffers fitted? This is w...

Shout if there are any specific measurements you need. My hood is not fitted at the moment and it will be some time before I get there, but scuttle and grill is fitted because I had to make the stays for the radiator.

Do not remember anymore whose car this is but he did a stellar job with his wheel arches.

Perhaps he can describe the process he used.

So yesterday I started the dreaded job of gluing the foam to the back wheel arches, which turned out a lot easier than I thought. I cut them just to the right size but once finished there was still some cleaning up to da as you can see in the last piece right at the bottom that i left for this morni...