machining the TC oil pump

Norman Golm · Post by **Norman Golm** » Wed Jun 25, 2014 7:54 am

I need to surface of the oil pump housing, cover and gears. I have had the parts to three shops and they don't seem to know how to hold the parts on a surface grinder. The surfaces are too rough to use the glass and sandpaper method. Is there another way of surfacing these parts? Or is there someone I can send the parts to?

Stan Teitge · Post by **Stan Teitge** » Wed Jun 25, 2014 12:21 pm

Have you tried a machine shop with a milling machine. It will get the surface perfectly flat and then you could do the glass and emery trick.

Stan

Steve Simmons · Post by **Steve Simmons** » Thu Jun 26, 2014 8:51 am

Send them to Butch Taras. He rebuilds pumps and does it properly. Uses a surface grinder and gets everything to proper clearance.

Roland “Butch” Taras
3733 Fourth Ave.
Glendale, CA. 91214
USA
Telephone / Fax +1 818-249-9031
mgyowner@yahoo.com

Norman Golm · Post by **Norman Golm** » Fri Jun 27, 2014 4:03 pm

Finally found a journey men tool maker and had it done right.

MG T-ABC

MG T-ABC

machining the TC oil pump

machining the TC oil pump

Re: machining the TC oil pump

Re: machining the TC oil pump

Re: machining the TC oil pump