Is there anyone that can post a picture of the starter switch for TA? I believe it goes directly on the starter?
This is the only picture I could find. Is it right? How is it connected to the starter motor cable?
TA starter switch
-
Rob Reilly
- Posts: 363
- Joined: Sun Feb 07, 2021 2:05 pm
- Location: Indiana, USA
-
Steve Simmons
- Site Admin
- Posts: 2750
- Joined: Wed Dec 26, 2012 10:48 am
- Location: Southern California
- Contact:
Re: TA starter switch
I'll try to find a photo. I may have one of a Riley switch, which is basically the same.
The pull cable slides through the nut on the arm, just like a TC switch. There's a screw (could be metric on a repro) that goes into the nut from the side closest to the camera.
The battery feed cable goes on the brass boss, and a BSF bolt threads in to secure it.
The switch is fastened to the starter with three screws (BSF I believe) and these are a grounding path so ensure the threads are clean!
The pull cable slides through the nut on the arm, just like a TC switch. There's a screw (could be metric on a repro) that goes into the nut from the side closest to the camera.
The battery feed cable goes on the brass boss, and a BSF bolt threads in to secure it.
The switch is fastened to the starter with three screws (BSF I believe) and these are a grounding path so ensure the threads are clean!