MPJG rebuild

[Mick bibby]

Hi guys looking for any advise on the rebuild of my MPJG . I had all white metal bearings a redone and a couple of conrods straightened, I bought it as seized and as you may see the thing had a lucky escape, car was in a very poor state hench the new everything
I can’t find a schematic for how it all goes together
I can remember how it does but I am just aware of falling into that trap just because it was on/in the engine doesn’t mean it should be there, looks like it’s been raced. I found bill Davis site which is superb but no detail , also it’s very tight to turn over and needs a short bar to move , I’ve read somewhere this is correct
Help
Regards Mick