XPAG Connecting Rod Needed

Discussion of TABC-related matters
Post Reply
Paul Mascuch
Posts: 15
Joined: Mon Jan 07, 2013 11:25 am
Location: Parma, Idaho

XPAG Connecting Rod Needed

Post by Paul Mascuch » Thu May 12, 2016 10:19 am

I am in the process of rebuilding the engine on my 1948 MGTC and I've got bad threads for the wrist pin clamp bolt in the small end of the #3 connecting rod. The bad rod without the bearing installed , including the cap and bolts weighs 623.6 grams.

Would anyone have a spare rod that could help me out that you would be willing to sell? If not, does anyone have an idea about how this could be successfully repaired?

Thank you.

Paul Mascuch
Top
User avatar
Gene Gillam
Posts: 1275
Joined: Wed Jan 02, 2013 4:52 pm
Location: Saucier, MS

Re: XPAG Connecting Rod Needed

Post by Gene Gillam » Fri May 13, 2016 1:05 pm

Paul...try contacting Bob Grunau of this group. He should have what you need: grunau.garage@sympatico.ca

Gene
Top
Tom Lange, MGT Repair
Posts: 310
Joined: Mon Jan 07, 2013 10:14 am

Re: XPAG Connecting Rod Needed

Post by Tom Lange, MGT Repair » Sat May 14, 2016 7:05 am

Let me know if you have no luck; I have a dozen or so rods I can check.

Tom Lange
MGT Repair
Top
Post Reply

Return to “TABC Chat”