MG T-ABC

The original floorboards of my TC have a steel angle section 1" x 1" x 13" long screwed on one flange to their rear extremity, the other flange being screwed to rear bulkhead where it meets the floor. I can find no reference to this part in any lists or manuals and I'm wondering if it was an original fitment or something added by a previous owner to reinforce the gap/joint between the floorboard and the bulkhead.

Can anyone confirm one way or the other? Thanks in anticipation

My '48 did not have any steel angle strips on the floorboards>

All of the TCs I have worked on (many) all had the angle piece you are referring to. If the floorboards have been replaced thy could have been left off.

It is original

Thanks for the feedback guys - looks like I need a new angle.