I have decided to try and go forth with a personal project in attempt to improve the Hub/Halfshaft mess on TC cars, but I need a small supply of old Hubs and Halfshafts in order to test my ideas physically. I do not care about the condition of the splines, or wear at all, actually! Practically anything that once *WAS* a TC hub will do! Sloppy fit in the splines? Wobbles all over the place? Not a problem at all.
This is probably going to take a few months to get off the ground, but I have high hopes at the moment. I am writing a new thread in the forum now which will offer a better explanation, titled "Hub To Halfshaft Friction Welding"
-Kam-