Hello, I'm looking for a good XPAG block for my project. No heads, crank, etc needed except the main bearing caps. I'd prefer the bore be no greater than 0.060" over because I have new pistons at 0.080" over. I live near Seattle, WA and am willing to drive a couple hundred miles.
Best regards,
Craig
XPAG engine block wanted (max bore 0.060" over)
-
craig.cootsona
- Posts: 24
- Joined: Mon Feb 03, 2014 10:21 pm
- Location: Tacoma, WA
-
craig.cootsona
- Posts: 24
- Joined: Mon Feb 03, 2014 10:21 pm
- Location: Tacoma, WA
Re: XPAG engine block wanted (max bore 0.060" over)
Found one. Thanks Basil Adams, we enjoyed the visit!