MG T-ABC

Looking for several parts to complete my MG TA (XPAG engine conversion) project. Mainly the front XPAG engine plate for MG TB/TC, the accelerator assembly (TA-TC) rear shock absorbers (TA) and the LH windscreen frame stanchion. Any offers welcome, phone +491794647165. Thanks for reading. Regards, Alex

Hi Alex and welcome to the forum. I too am i need of a reasonable xpag font engine plate. What I may say is that the accelerator assembly is different between the TA/TB and the TC, which is referenceable to the holes in the bulkhead. The TA had Luvax rear shockers which hard to find I'm told. There are some w/screen stanchions for sale on ebay in the US but they are extortionate - good luck

Hi Chris, thank you for your kind reception and advice. I think I should introduce myself a bit. A couple of years ago I was lucky enough to by an early cycle wings TA from an aquaintance englishman, when he moved back to england and could not take the car along. It was partly disassembled since a couple of years after an engine issue. The MPJG needed a complete rebuild and welding and there was some more to fix up. Finally to my great pleasure the old lady is back on the road. The spares I am looking for are for her garage companion, a 1937 TA Ex-Lancashire police car, which is subject to a complete frameoff nut and bolt rebuild. In relation to the windscreen frame part I unfortunately used the wrong term. In fact I am looking for the LH side support. The windscreen arrangement I bought via ebay came with two RH supports. Probably someone out there must have two LH supports. When I find two front engine plates I`ll let you know. Best wishes, Alex

Did you get the engine mount plate? I have one for sale, soon. Jan

Hi Jan, thank you for your offer. Still looking for a good one. Regards Alex

Apparently, I can't send a pic., here! Jan
jgarnaes@yahoo.com