MG T-ABC

Posted: **Wed Apr 11, 2018 8:45 am**

Hello, I'm looking for a good XPAG block for my project. No heads, crank, etc needed except the main bearing caps. I'd prefer the bore be no greater than 0.060" over because I have new pistons at 0.080" over. I live near Seattle, WA and am willing to drive a couple hundred miles.

Best regards,
Craig

Posted: **Sun Jul 01, 2018 4:44 pm**

Found one. Thanks Basil Adams, we enjoyed the visit!

MG T-ABC

XPAG engine block wanted (max bore 0.060" over)

XPAG engine block wanted (max bore 0.060" over)

Re: XPAG engine block wanted (max bore 0.060" over)